Lighting - Rigging & Truss

12" x 12" Box Truss

  • Available in 2', 3', 4', 5', 8' & 10' sections
  • Silver or black finish
  • Main chords are 2" OD x 1/8" - 50.8 mm OD x 3.1 mm aluminum
  • Diagonals are 1" OD x 1/8" - 25.4 mm OD x 3.1 mm aluminum
  • Fabricated by certified welders

20.5" x 20.5" Box Truss

  • Available in 3', 5', 6' & 10' sections
  • Silver or black finish
  • Main chords are 2" OD x 1/8" - 50.8 mm OD x 3.1 mm aluminum
  • Diagonals are 1" OD x 1/8" - 25.4 mm OD x 3.1 mm aluminum
  • Fabricated by certified welders

26" x 20.5" Conventional PRT

  • Equipped with bolts
  • Can be supplied with or without Pars
  • Main chords are 2 OD x 1/8 aluminum
  • Diagonals are 1 OD x 1/8 aluminum
  • 26" x 30" x 7™9"
  • Fabricated by certified welders

Tyler HUD Pre Rigged Moving Light Truss

  • Reduced load-in time & fuel consumption
  • Eliminates fixture cases
  • Tyler GT protects your fixtures
  • Dramatically reduce load-in & load-out time
  • 10' Sections
  • 212 pounds with legs, 144 pounds without legs

CM Lode Star 1 Ton Hoist

  • 1 Ton capacity
  • Beam connector
  • 60' chain
  • Maximum speed: 16' per minute
  • Designed for heavy-duty stage/theatrical applications
  • Safe & quick voltage change
  • Adjustable limit switch prevents load from over-travel in both up & down directions
  • Overload protection helps prevent lifting of dangerous loads
  • AC electromechanical brake

CM Lode Star 1/2 Ton Hoist

  • 1/2 Ton capacity
  • Beam connector
  • 60' chain
  • Maximum speed: 16' per minute
  • Designed for heavy-duty stage/theatrical applications
  • Safe & quick voltage change
  • Adjustable limit switch prevents load from over-travel in both up & down directions
  • Overload protection helps prevent lifting of dangerous loads
  • AC electromechanical brake

Skjonberg CS 800 Hoist Control

  • Enables 8 chain motors to be run individually or in unison
  • Power distribution & relay control for the hoists reside in the same compact unit
  • Runs 3 phase motors at 208V-220V
  • 30 amp input provides adequate current to run (8) 1hp motors
  • 4 circuit breakers protect 2 motors
  • Fully enclosed chassis can be mounted onto truss using half couplers, into a CS model road case, or any standard rack
  • Provides the relay control interface between the CHCII computer & the motors

We'll answer all of your questions. Let's start planning.